Thanks very much for your timely reply. The thing is, I use port 12 as the port for communicating with controller. I need to specify a vlan for communication betwee OFS and POX. I used VLAN 1, but the status is still disconnected. They can ping each other but can not connected.
Another weird thing is that I use port 1 and 2 for connecting two physical servers so that VMs can talk to each other. As I tested yesterday, the weird thing is, even I did not run the openflow, two VMs can still ping each other through port 1 and 2. Based on my understanding, if I enabled openflow on the HP switch, without running application on controller, like l2_learning switch, the traffic of port 1 and 2 can not be forwarded. Any thought ? Thanks very much. On Wed, Feb 20, 2013 at 7:09 PM, Steve Noble <sno...@sonn.com> wrote: > Hi Terry, > > When I did my testing I used the configuration outlined in this post > > http://www.routeranalysis.com/state-of-openflow-2012-day-56-notes-on-hp/ > > Let me know of that helps. > On Feb 20, 2013 4:01 PM, "terryxing" <xingtia...@gmail.com> wrote: > >> Dear All, >> >> I am configuring the HP 3500yl openflow switch. I already burn the >> firmware K15.10 version into the secondary OS of the HP openflow switch and >> boot as the secondary OS. I think the openflow is already successfully >> installed on the HP switch since I can use openflow CLI to configure. The >> thing is , I can not make my openflow swtich talk to the controller. >> >> I configure the 192.168.1.66 as the ip of HP OFS and 192.168.1.60 for the >> POX controller as a virtual machine (the physical server is connected to HP >> OFS) They can ping each other which means the connection is good. >> >> But when I configure the OFS by following the manual for K15.10 version. >> I can not make OFS and POX connected. I configure the instance as aggregate >> mode but I dont know how can I specific the vlan for controller and vlan >> for management. The POX is connecting to HP OFS through port 12 which >> belongs to VLAN1 (the default VLAN). Also, in the manual, there is one >> command line which can not be executed, which is "openflow instance >> aggregate member vlan vlan-id" There is not member key words. >> >> Can anyone help ? I have been struggling on this for 3 days. >> >> Thanks very much. >> >> -- >> Best regards, >> >> >> >> Terry >> >> _______________________________________________ >> openflow-discuss mailing list >> openflow-discuss@lists.stanford.edu >> https://mailman.stanford.edu/mailman/listinfo/openflow-discuss >> >> -- Best regards, Terry
_______________________________________________ openflow-discuss mailing list openflow-discuss@lists.stanford.edu https://mailman.stanford.edu/mailman/listinfo/openflow-discuss
