I was using openocd with a STM32 value line discovery at the end of
August with no problems now it comes up with the following error:
Open On-Chip Debugger 0.9.0-dev-00161-g9c47dc9 (2014-09-29-23:55)
Licensed under GNU GPL v2
For bug reports, read
http://openocd.sourceforge.net/doc/doxygen/bugs.html
Info : The selected transport took over low-level target control. The
results might differ compared to plain JTAG/SWD
adapter speed: 1000 kHz
adapter_nsrst_delay: 100
Info : clock speed 1000 kHz
in procedure 'init' called at file "openocd.cfg", line 3
in procedure 'ocd_bouncer'
in procedure 'transport'
Runtime Error: openocd.cfg:3:
in procedure 'script'
at file "embedded:startup.tcl", line 58
in procedure 'init' called at file "openocd.cfg", line 3
I am on Gentoo so something else may have changed, I am just checking
here just in case somebody has already seen this fault.
On Gentoo I use the 9999 flag so I get openocd from git and I haven't
been paying attention to the changes.
My config is default:
add_script_search_dir /usr/share/openocd/scripts
source [find board/stm32vldiscovery.cfg]
init
reset init
I have a Discovery F4 (stlink V2) that still works fine.
Any hints gratefully received.
Billy
------------------------------------------------------------------------------
Meet PCI DSS 3.0 Compliance Requirements with EventLog Analyzer
Achieve PCI DSS 3.0 Compliant Status with Out-of-the-box PCI DSS Reports
Are you Audit-Ready for PCI DSS 3.0 Compliance? Download White paper
Comply to PCI DSS 3.0 Requirement 10 and 11.5 with EventLog Analyzer
http://pubads.g.doubleclick.net/gampad/clk?id=154622311&iu=/4140/ostg.clktrk
_______________________________________________
OpenOCD-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/openocd-devel
