Am 20.11.18 um 17:21 schrieb Antonio Borneo: > On Tue, Nov 20, 2018 at 1:43 PM Oleksij Rempel <li...@rempel-privat.de> wrote: >> >> Hi all, >> >> i started this discussion on the irc #openocd. As PaulFertser suggested, >> lets move it to the mailing list. >> >> To make at least some of the commands more consistent, i decided to >> rework adapter related part. Initial patch is here: >> http://openocd.zylin.com/4774 >> >> Here are the old variants of adapter related commands: >> ftdi_location <location> >> interface <name> >> interface_list >> interface_name >> adapter_nsrst_delay >> adapter_nsrst_assert_width >> interface_transports >> adapter_khz >> >> here is my new: >> adapter usb location <location> (set usb location of usb adapter) >> adapter driver set <name> (select adapter driver) >> adapter driver get (get configured driver name) >> adapter driver list (list build in drivers) >> adapter srst delay_after (delay after srst deasserted) >> adapter srst width (assertion pulse width) >> adapter transports (set list of supported transports by adapter) >> adapter khz (set clock rate of TCLK line) >> >> By "adapter khz" and "adapter transports", i'm not 100% sure. For the >> firs one, I can imagine some thing like "adapter tclk rate <rate>". > > ST-Link in SWIM mode for STM8 only recognize adapter_khz zero or > non-zero, corresponding at low and high speed. > Would be nice to use "adapter speed" instead of "adapter khz". > But then what is the unit? Hz or kHz or "bool" for high/low?
I need to think about it, probably even move it to the separate patch... > More general, would be also nice to collect under a single command > "adapter usb vid_pid" all the various "aice vid_pid", "ftdi_vid_pid", > "hla_vid_pid", "usb_blaster_vid_pid". > Same for a single "adapter usb serial" instead of "aice serial", > "cmsis_dap_serial", "ftdi_serial", "hla_serial", "jlink serial", > "kitprog_serial", "xds110_serial" ACK :) -- Regards, Oleksij _______________________________________________ OpenOCD-devel mailing list OpenOCD-devel@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/openocd-devel
