https://www.adafruit.com/products/70 is a great serial cable. It's used for ttl level serial. (If you have to solder to the board, it's probably ttl. If there is an actual serial port, then it's 12 v serial. Different device)
On Sat, May 5, 2012 at 9:16 AM, Alberich de megres <[email protected]> wrote: > One more last question: > > which serial/jtag cable do you use? (if it is cheap, better) > > thanks! > > > On Wed, May 2, 2012 at 5:55 PM, Jonathan Bennett <[email protected]> > wrote: >> On Sat, Apr 28, 2012 at 9:22 AM, Alberich de megres >> <[email protected]> wrote: >>> Hi, >>> >>> @Jonathan, >>> how get access to the bootloader? >>> do you send it to the router by streaming, or write it and then boot it? >> >> Get a serial port and watch the output as you turn it on. Normally >> there will be a message about how to interrupt the boot loader. Then >> you send your image to ram, either over tftp or the serial connection. >> then you just boot from where you loaded it in ram. >> _______________________________________________ >> openwrt-devel mailing list >> [email protected] >> https://lists.openwrt.org/mailman/listinfo/openwrt-devel > _______________________________________________ > openwrt-devel mailing list > [email protected] > https://lists.openwrt.org/mailman/listinfo/openwrt-devel _______________________________________________ openwrt-devel mailing list [email protected] https://lists.openwrt.org/mailman/listinfo/openwrt-devel
