Thanks Hauke,
It works with last you said driver "kmod-brcm-wl" . Here the interface:
wl0 IEEE 802.11abgn ESSID:""
Mode:Managed Frequency:2.412 GHz Access Point: Not-Associated
Bit Rate:44 Mb/s Tx-Power:32 dBm
RTS thr:off Fragment thr:off
Power Management:off
Link Quality=5/5 Signal level=0 dBm Noise level=0 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
I have tried with "kmod-b43" and i cannot view the wireless interface,
and i don't locate a module with the words "ssb", could anyone say
witch is exactly the module name of this driver?
thanks so much,
aitor
2012/10/15 Aitor Cuartango <[email protected]>:
> Thank you very much !
> i'll test it and i'll reply again this message to confirm it.
>
> best regards,
> aitor
>
> 2012/10/14 Hauke Mehrtens <[email protected]>:
>> On 10/13/2012 09:24 AM, Aitor Cuartango wrote:
>>> Hi all,
>>> do anyone have experience with Broadcom BCM43222? Is very cheap in
>>> eBay and i have buy one to have a B/G/N network working in my old
>>> router.
>>>
>>> I have installed in my Asus WL-500g Premium flased with Attitude
>>> Adjustment (12.09-beta), but i cannot locate the apropiate driver to
>>> get it working...
>>>
>>> Do anyone have experience with this card?
>>>
>>> thanks!
>>> aitor
>>
>> BCM43222 is supported by ssb and b43 and should work in OpenWrt
>> 12.09-beta with 11g rates in 2.4 GHz band, it could also work with
>> broadcom-wl.
>>
>> Hauke
_______________________________________________
openwrt-users mailing list
[email protected]
https://lists.openwrt.org/mailman/listinfo/openwrt-users
