On Sunday 13 January 2008, Paul Alfille wrote: > Specifically, each of the "files" represent properties of actual DS18S20 > chip. This chip has high and low temperature thresholds for setting the > alarm state. > You can read and write (set) these thresholds with owfs in the very > intuitive manner of reading and writing to that "file". > e.g: > echo "15" > /mnt/1wire/bus.0/10.53AE60010800/templow
I have a question about the templow and temphigh alarm state. What use are they? According to the man page: > Note that alarms are not implemented. Right now mine are high=167 low=158. What would be different if wanted an alarm point checked to just read the temperature? If you can point me somewhere that describes their use better please do. Right now the just seem useless. Thanks, Dave ------------------------------------------------------------------------- Check out the new SourceForge.net Marketplace. It's the best place to buy or sell services for just about anything Open Source. http://ad.doubleclick.net/clk;164216239;13503038;w?http://sf.net/marketplace _______________________________________________ Owfs-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/owfs-developers
