Markus,

Thanks for the suggestions.  This is the route I started down.  I have a
camp-on ammeter, and am able to measure significant amperes across the
negative terminal when the car is running.  I  watch it go down to ~2
amperes when I shut off the car.  I then start pulling fuses and can see
some reduction, but my fear is that using a camp-on ammeter my readings are
not that accurate (correct me if I am wrong).  And after several nights of
not picking the right fuse I am getting a little annoyed.

If I disconnect the battery completely, it holds a charge.

I think you might be right, an in-line ammeter might be more accurate and
help me narrow down the cause.

Anyone have an idea on what the typical draw should be on a car battery so
that it can hold a charge for days at a time?  I would guess milliamps?


FYI  This is a 2007 Honda Odyssey, and has a good amount of electronics.  



Jason C. Lamb
617-512-6064
[email protected]
http://www.linkedin.com/in/jasonclamb


-----Original Message-----
From: Markus Gaugusch [mailto:[email protected]] 
Sent: Thursday, June 16, 2011 2:08 PM
To: OWFS (One-wire file system) discussion and help
Subject: Re: [Owfs-developers] Monitoring Battery Voltage

On Jun 16, Jason C. Lamb <[email protected]> wrote:

> I am fairly new to 1-wire, though I setup a temperature probe about 4 
> years ago with excellent success.  Today I am looking to 1-wire to 
> monitor the voltage on my car battery.  It seems to drain over night.  
> I can measure the voltage at night using a multi-meter (13.1 VDC) and 
> by the morning it is 0.2 VDC.  The problem I am not sure if the 
> voltage drop is slow and steady, or there is a defect in the battery that
is causing a sudden drop off.

While this is not a 1-wire solution, I'd rather pull some fuses of
suspicious consumers (like radio) and see if the problem persists. If you
know which fuse is relevant for the battery draining you can find the
problem more easily.

Additionally, you don't need a voltage meter but an ampere meter to measure
the current. Voltage won't tell you how much power is consumed (it will only
tell you when the power is over, that's it).

But: This is more dangerous, as you have to put the ampere meter in-line
with the consumer, and not parallel like a voltage meter. Some devices suck
significant amounts of power, so be prepared for some sparks to fly!

I'd probably pull out a fuse, and put in an ampere meter instead. Another
suspect (apart from the radio) is any consumer in your doors. The cables
there tend to loose their insulation over time and can cause more or less
significant current flow.


best regards,
Markus

----------------------------------------------------------------------------
--
EditLive Enterprise is the world's most technically advanced content
authoring tool. Experience the power of Track Changes, Inline Image Editing
and ensure content is compliant with Accessibility Checking.
http://p.sf.net/sfu/ephox-dev2dev
_______________________________________________
Owfs-developers mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/owfs-developers


------------------------------------------------------------------------------
EditLive Enterprise is the world's most technically advanced content
authoring tool. Experience the power of Track Changes, Inline Image
Editing and ensure content is compliant with Accessibility Checking.
http://p.sf.net/sfu/ephox-dev2dev
_______________________________________________
Owfs-developers mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/owfs-developers

Reply via email to