Only my pc got authenticated via dot1x and no authentication for phone . Although my phone keeps on working no matter it is not authenticated.
But if I used "authentication host mode as multi-domain" instead of multi-host all stops because my phone not gets authenticated then and struck in provisioning. On Mon, Mar 22, 2021, 22:32 Ludovic Zammit <[email protected]> wrote: > Connect both of them and show me the result of this command: > > show authentication session int YOUR_INTERFACE detail > > Thanks, > > > Ludovic Zammit > [email protected] :: +1.514.447.4918 (x145) :: www.inverse.ca > Inverse inc. :: Leaders behind SOGo (http://www.sogo.nu) and PacketFence > (http://packetfence.org) > > > > > > > > > On Mar 22, 2021, at 12:55 PM, NITISH AGGARWAL <[email protected]> > wrote: > > Voice vlan 100 and access vlan 10 > > On Mon, Mar 22, 2021, 22:23 Ludovic Zammit <[email protected]> wrote: > >> What’s your voice VLAN id ? >> >> Thanks, >> >> >> Ludovic Zammit >> [email protected] :: +1.514.447.4918 (x145) :: www.inverse.ca >> Inverse inc. :: Leaders behind SOGo (http://www.sogo.nu) and PacketFence >> (http://packetfence.org) >> >> >> >> >> >> >> >> >> On Mar 22, 2021, at 12:13 PM, NITISH AGGARWAL <[email protected]> >> wrote: >> >> switchport mode access >> Switchport access vlan 10 >> switchport voice vlan 100 >> switchport port-security mac-address sticky 0200.000x.xxxx >> switchport port-security maximum 2 >> authentication host-mode multi-host >> authentication order dot1x mab >> authentication priority dot1x mab >> authentication port-control auto >> authentication periodic >> mab >> no snmp trap link-status >> dot1x pae authenticator >> dot1x timeout quiet-period 2 >> dot1x timeout tx-period 3 >> >> >> On Mon, Mar 22, 2021, 20:12 Ludovic Zammit <[email protected]> wrote: >> >>> Hello, >>> >>> Show me the interface configuration that you have on your switch where >>> you plug your phone. >>> >>> Thanks, >>> >>> >>> Ludovic Zammit >>> [email protected] :: +1.514.447.4918 (x145) :: www.inverse.ca >>> Inverse inc. :: Leaders behind SOGo (http://www.sogo.nu) and PacketFence >>> (http://packetfence.org) >>> >>> >>> >>> >>> >>> >>> >>> >>> On Mar 18, 2021, at 8:27 AM, NITISH AGGARWAL via PacketFence-users < >>> [email protected]> wrote: >>> >>> Hi, >>> >>> I have setup PacketFence as per guide. Dot1x is enabled and working but >>> I am not able to use MAB. Due to which my ip phones are not get >>> authenticated. >>> >>> In switch (cisco 2960) I was using authentication host-mode as >>> multi-domain and MAB is enable. But since it was not authenticating I am >>> using host-mode as multi-host. Now my system and phone is working but it is >>> not authenticating my ip phone which is causing problem sometimes. I am not >>> able to resolve the issue please suggest what needs to be done >>> _______________________________________________ >>> PacketFence-users mailing list >>> [email protected] >>> https://lists.sourceforge.net/lists/listinfo/packetfence-users >>> >>> >>> >> >
_______________________________________________ PacketFence-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/packetfence-users
