Have you tried loading/running it on POSE?
Also make sure you don't have any resources that are larger than 64K.
-----Original Message-----
From: Eric Snider <[EMAIL PROTECTED]>
To: [EMAIL PROTECTED] <[EMAIL PROTECTED]>
Date: Wednesday, October 13, 1999 5:12 AM
Subject: Re: <x> 16 bit code reference to <y> is out of range
>At 9:41 AM -0500 10/12/99, Jun-Kiat Lam wrote:
>>For the '16-bit code reference...out of range' error, you might want to
>>check out the FAQ at http://www.metrowerks.com/pda/palm/faq/7.stm since it
>>explains this error and some common solutions.
>
>I followed the advice in the FAQ. When I change the Code Model to
>Smart instead of Small I can build the project. But when I try to
>install the app on the emulator or on my Palm V things go horribly.
>
>The emulator says "Could not install the Palm OS file 'Ultimate.prc'
>because Palm OS error 0x0201 (dmErrMemError) occurred." I'm not sure
>what that's about. The only change was to switch the code model. If I
>run it under the simulator then everything works fine. It was also
>working well not too long ago in the emulator and on my Palm V.
>
>When I installed it on my Palm V I got a fatal error when it finished
>installing. I had to do a hard reset to make my Palm work again.
>
>I'm frustrated because I've got some cool stuff working in my
>solitaire game now but I can't show anyone on an actual Palm!
>
>I've been trying to make jump islands and move code around for hours
>now. I'm not getting very far. The code is in a lot of pieces that
>call each other and it's difficult for me to do this by hand. Has
>anyone else been able to change the Code Model to "Smart" and used
>the results successfully? Am I doing something wrong?
>
><Later> I just made a little progress. I realized I could remove
>MacsBug symbols from the build. That made my code a lot closer
>together. Phew. I think I can build again. I'd still like to get the
>"Smart" Code Model stuff working though. It should work for the Palm,
>right?
>
>Thanks!
>
>Eric
>
>
