I am using the debugger with a IIIc and POSE, and I've found the
connection EXTREMLEY buggy (usually I have an 80% failure rate), and
that didn't change with the latest update.
Here are things I do to attempt to connect to a debug device, in orders
of increasing desperation:
=> Disable all breakpoints, or if none are enabled, enable one. (This
works some of the time.)
=> Reset the device.
=> In POSE, load a fresh ROM
=> Completely rebuild my project
=> Close CodeWarrior and reopen it.
In general, I never expect to get too many successful connections before
i have to reload Codewarrior.
It's inconvenient, and on a larger project the rebuilds would REALLY be
a pain, but when I perservere like this I can usually get a debug
connection often enough to do some basic test runs.
Now, I'm not using a visor, but maybe some of this will help.
- Jeff
Dan Samber wrote:
>
> Until now, I have been happily debugging my programs on my Visor.
> >From everything I read, it seems like I should be able to step through
> my code and use the Codewarrior debugger on POSE instead.
>
> So far..... nuttin! Either I get a "failed to connect to remote" or some
> mysterious error number from Codewarrior. I thought that all I'd have to
> do was have POSE running and have my palm connection setting set
> to "emulator". I even tried writing the infamous shortcut .. 2 into POSE
> (which is what I do on my Visor to put it into console mode).
>
> I have read GOBS of documentation on the debugger itself... to no avail!
>
> Please help me save my batteries!
>
> Thanks,
>
> Dan
>
> --
> For information on using the Palm Developer Forums, or to unsubscribe, please see
>http://www.palmos.com/dev/tech/support/forums/
--
For information on using the Palm Developer Forums, or to unsubscribe, please see
http://www.palmos.com/dev/tech/support/forums/
