I am trying to figure out drive termination. I have two hard drives and a CD ROM
drive on one SCSI cable.
The hard drives have three pairs of pins, but none say termination. The CD ROM has
four pairs of pins. The last pair says something about termination.
Should my hard drives be set to ID 0 and ID 1 or 2 while my CD ROM is ID 3? Will
that enable termination?
Also, does the terminated device need to be on the last plug of the ribbon, or does
it matter? The original setup had the CD ROM on the middle plug and the hard drive at
the end.
Thanks for the help
Kevin
--
PCI-PowerMacs is sponsored by <http://lowendmac.com/> and...
Small Dog Electronics http://www.smalldog.com | Refurbished Drives |
-- Sonnet & PowerLogix Upgrades - start at $169 | & CDRWs on Sale! |
Support Low End Mac <http://lowendmac.com/lists/support.html>
PCI-PowerMacs list info: <http://lowendmac.com/lists/pci-powermacs.shtml>
--> AOL users, remove "mailto:";
Send list messages to: <mailto:pci-powermacs@;mail.maclaunch.com>
To unsubscribe, email: <mailto:pci-powermacs-off@;mail.maclaunch.com>
For digest mode, email: <mailto:pci-powermacs-digest@;mail.maclaunch.com>
Subscription questions: <mailto:listmom@;lowendmac.com>
Archive:<http://www.mail-archive.com/pci-powermacs%40mail.maclaunch.com/>
---------------------------------------------------------------
>The Think Different Store
http://www.ThinkDifferentStore.com
---------------------------------------------------------------
