> I installed the card and USB Card Adapter Support 1.4.1 and all
>software and drivers for my Fuji Finepix 3800 digital camera and USB
>zip. Nothing works. My system seems to see the card but only gives
>the card name as "pci 3083, e0" and vendor ID as "1033". Nothing else.
>
>I searched all specs on the card and 8500 and found the card says
>"32-bit 33 Mhz host interface compliant to PCI specification release
>2.2". The 8500 PCI 2.0 specification.
>
>Golly, could this be the problem? Backwards compatibility...Yes? No?
>
>Mike
I got a very cheap 2 port usb pci card - for my Epson 1200 which has
serial, parallel and usb. When I installed it nothing showed in the ASP
pci devices but usb 0 1.4.6 'no devices found on this bus' showed up at
the top of ASP.
Plugged the printer in and opened Chooser and there was the usb port
ready to select - prints fine even through a rip but the system will tell
me nothing about it - I may give TattleTech a run out.
Pete
--
PCI-PowerMacs is sponsored by <http://lowendmac.com/> and...
Small Dog Electronics http://www.smalldog.com | Refurbished Drives |
-- Sonnet & PowerLogix Upgrades - start at $169 | & CDRWs on Sale! |
Support Low End Mac <http://lowendmac.com/lists/support.html>
PCI-PowerMacs list info: <http://lowendmac.com/lists/pci-powermacs.shtml>
--> AOL users, remove "mailto:";
Send list messages to: <mailto:[EMAIL PROTECTED]>
To unsubscribe, email: <mailto:[EMAIL PROTECTED]>
For digest mode, email: <mailto:[EMAIL PROTECTED]>
Subscription questions: <mailto:[EMAIL PROTECTED]>
Archive:<http://www.mail-archive.com/pci-powermacs%40mail.maclaunch.com/>
Using a Mac? Free email & more at Applelinks! http://www.applelinks.com
