In a message dated 6/16/03 7:07:34 PM, [EMAIL PROTECTED] writes: << > Could a Beige G3 mobo be put into a 7200 case with no trouble > ? Would the power supply be adequate ? I have severe doubts. I think the rear ports would be all out of whack and I'm pretty sure the power supply would not mate up without some alterations. Then there's the real (technical stuff) like voltages. >>
It's been done before. The PCI ports are in the right place. Some accommodation would be required for the A/V transition card. The Beige G3 DT power supply is the same as the 7300 or 7500/7600/7200 power supply, except for the mobo power cables ... a single 20 pin in the DT case, a 10-pin and a 24-pin in the 7300 case, and a 10-pin and a 22-pin in the 7500/7600/7200 case. The DT case is mostly the same as the other cases mentioned, except for the bottom metalwork and the back metalwork and plastic. -- PCI-PowerMacs is sponsored by <http://lowendmac.com/> and... Small Dog Electronics http://www.smalldog.com | Refurbished Drives | -- Sonnet & PowerLogix Upgrades - start at $169 | & CDRWs on Sale! | Support Low End Mac <http://lowendmac.com/lists/support.html> PCI-PowerMacs list info: <http://lowendmac.com/lists/pci-powermacs.shtml> --> AOL users, remove "mailto:"; Send list messages to: <mailto:[EMAIL PROTECTED]> To unsubscribe, email: <mailto:[EMAIL PROTECTED]> For digest mode, email: <mailto:[EMAIL PROTECTED]> Subscription questions: <mailto:[EMAIL PROTECTED]> Archive:<http://www.mail-archive.com/pci-powermacs%40mail.maclaunch.com/> Using a Mac? Free email & more at Applelinks! http://www.applelinks.com
