On Mon, 14 Jul 2003 08:25:45 -0400 Nick Hull <[EMAIL PROTECTED]> wrote:
>I put a 2nd hard drive in my PM7200, and it doesn't show up on the desktop. >The jumper panel; >Delay motor Start DS I added a jumper here since it is the 2nd >drive, is that OK? Even if you did the drive should startup after the main drive boots. Usually I keep it unjumpered. >I tried changing the ID to 1, I think that is done by shorting the 1st >(right) pair of the HDA connector. : : The ID came out ID=4 > Could it be that the pin pair you jumpered was actually No. 4? See if PA (Parity) pins are jumpered; otherwise the drive will default to ID No.6 no matter how you jumper it. >My computer is a PM7200/75 (soon to be 7200/120) running OS 7,6,1, Disk >Doctor says everything is OK. > >Any idea how I can make the drive visible? All help appreciated. If it still doesn't mount low level format the drive with Drive Setup or any 3rd party utility like FWB's Hard Disk Toolkit, LaCie Silverlining, Mt. Everything. Charlie -- PCI-PowerMacs is sponsored by <http://lowendmac.com/> and... Small Dog Electronics http://www.smalldog.com | Refurbished Drives | -- Sonnet & PowerLogix Upgrades - start at $169 | & CDRWs on Sale! | Support Low End Mac <http://lowendmac.com/lists/support.html> PCI-PowerMacs list info: <http://lowendmac.com/lists/pci-powermacs.shtml> --> AOL users, remove "mailto:"; Send list messages to: <mailto:[EMAIL PROTECTED]> To unsubscribe, email: <mailto:[EMAIL PROTECTED]> For digest mode, email: <mailto:[EMAIL PROTECTED]> Subscription questions: <mailto:[EMAIL PROTECTED]> Archive:<http://www.mail-archive.com/pci-powermacs%40mail.maclaunch.com/> Using a Mac? Free email & more at Applelinks! http://www.applelinks.com
