On 10/27/06, William Robb <[EMAIL PROTECTED]> wrote: > > ----- Original Message ----- > From: "Toine" > Subject: Re: OT: Finally, Epson R2400 > > > >I also enabled myself with the 2400 recently. The paper I have > > available is premium glossy photo. > > The (advanced) settings of the printer driver are confusing. What > > would be the best settings for printing in photoshop (16 bit, > > adobeRGB, calibrated monitor). The prints (with the default driver > > settings) are a little low in contrast and saturation compared with > > the monitor. I played with some settings (epson default vs adobeRGB) > > without succes. > > Set the printer driver to no colour management, then set Photoshop to > colour manage the printing using the appropriate paper profile.
Bill, I just purchased an R220 this week. i've made a few successful prints so far, but your advice is contrary to what I've been doing. Perhaps you can shed some light on it. I have my colourspace in CS2 as AdobeRGB, Gamma 1.8. The settings in "Print with Review" are set to "let photoshop manage colours" with those settings. The Epson program pops up after I finish with the CS2 print settings. I selected "Colour manage" with the same settings that I have in CS2. It seems to work fine. Is this alright? My prints seem fine. Is there an additional advantage to your method? Thanks. Mike -- -- Remember to Breathe -- MichaelHamilton.ca -- PDML Pentax-Discuss Mail List [email protected] http://pdml.net/mailman/listinfo/pdml_pdml.net
