Thanks Antti-Pekka, I'm on a Mac and have reinstalled the latest driver. I'm beginning to think it's a printer problem. It's only a few weeks old, perhaps the store will exchange it. Paul On Jan 22, 2007, at 3:50 AM, Antti-Pekka Virjonen wrote:
> Hi Paul, > > Check your printer driver. If you're on Windows, it might be that > you're using some Windows auto-installed driver for your printer > which does not work (in this case you are likely to have several > drivers installed for the printer). Choose the correct Epson driver > or re-install it. I have seen this happen on a couple of computers. > > Antti-Pekka > > ________________________________________ > > Antti-Pekka Virjonen > > Computec Oy > R&D Turku > Fiskarsinkatu 7 D > FIN-20750 Turku Finland > > Puh. +358 20 7908 300 > GSM +358 500 789 753 > Telefax +358 20 7908 319 > > Y-tunnus 1974184-5 > Kotipaikka Helsinki > > www.computec.fi > > >> -----Original Message----- >> From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf >> Of Paul Stenquist >> Sent: Sunday, January 21, 2007 6:27 PM >> To: Pentax-Discuss Mail List >> Subject: OT: Help! R2400 printing problem persists >> >> I've checked all the variables numerous times, and to the best of my >> knowledge, they're correct. The color space of both the file and the >> working space is correct. I reinstalled the Epson print drivers. Still >> no luck. Here are my settings (PhotoShop CS): >> Settings: U.S. Prepress Defaults >> >> RGB Working Space: Adobe RGB (1998) >> Gray: Dot Gain 20% >> Spot: Dog Gain 20% >> >> Color Management Policies >> RGB Preserve Embedded Profiles >> >> Use black point compensation is checked >> Use Dither (8-bit per channel images) is checked >> >> >> >> Image Colorspace: Adobe RGB (1998) >> >> >> >> Print with Preview: >> >> Source Space: >> Document is checked, and ithe indication is Document: Adobe RGB >> (1998 >> >> Pring Space: >> Profile: Same as source >> >> >> In the print Box >> >> The preset is Premium Lustre. If I look under "print settings," I see >> Ultra Premium Photo Paper Luster (that's the paper I'm using). The >> mode >> is advanced. The print quality is Photo RPM and Finest Detail is >> checked. Scrolling to "Color Management," I see it's set to off. >> >> >> I'm going to try again, changing Print Space in the Print with Preview >> box to Adobe 98 rather than same as source. I'll set intent to >> relative >> colorimetric. But I'd appreciate any feedback on the above settings. >> If >> I can't get anywhere, I'm going to change all the ink cartridges. >> Thanks for any help. >> Paul >> >> >> -- >> PDML Pentax-Discuss Mail List >> [email protected] >> http://pdml.net/mailman/listinfo/pdml_pdml.net > > -- > PDML Pentax-Discuss Mail List > [email protected] > http://pdml.net/mailman/listinfo/pdml_pdml.net > -- PDML Pentax-Discuss Mail List [email protected] http://pdml.net/mailman/listinfo/pdml_pdml.net
