How about this...use a bayonet body cap mounted bayonet up in the case
and use a double rear lens cap on the lens. Lens fits into one side of
the double cap and the other side captures the bayonet body cap. Will
probably cost about $20/lens but might be cheaper and certainly more
available than something 3D printed.
-p
On 8/6/2021 3:17 AM, Larry Colen wrote:
What I’d really like to do is 3-d print back caps that had tabs on the outside,
and basically make bayonet mounts for them, so that I could latch them into the
hard case, but when I wanted to put them in a smaller camera bag, I’d take out
the lens, back cap and all, and just go with that.
--
Larry Colen
l...@red4est.com
--
%(real_name)s Pentax-Discuss Mail List
To unsubscribe send an email to pdml-le...@pdml.net
to UNSUBSCRIBE from the PDML, please visit the link directly above and follow
the directions.
--
Paul Sorenson
Studio1941
Sooner or later "different" scares people.
--
%(real_name)s Pentax-Discuss Mail List
To unsubscribe send an email to pdml-le...@pdml.net
to UNSUBSCRIBE from the PDML, please visit the link directly above and follow
the directions.