Hi Dennis,
AFAIK, selecting OrCAD style is the same as fixed size, if you then uncheck it, you will have to undo the damage, i.e. re size them to the sizes that then make them connect. Darren Moore > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] On Behalf Of Dennis Saputelli > > > Hi all > > can someone please (re)explain to me about "Orcad Ports" > in 99SE Tools Prefs > > I have schematic design that came from DXP saved back to > 99SE > > a lot (but not all) of the ports were not attached to their wires > > i made them bigger and smaller as needed and all was well > > now some days later opening the file on another machine > the ports are all mis-sized again, this time usually too long > and overlapping the net label > > i remembered this was maybe "Orcad Ports" > > it was checked on this machine > > i unchecked it, no change > > saved files, restarted protel, no change > > any clues why they jump around in size, aparently when working from > different machines ? > > Dennis Saputelli > > ______________________________________________________________ > _________ > Integrated Controls, Inc. Tel: 415-647-0480 EXT 107 > 2851 21st Street Fax: 415-647-3003 > San Francisco, CA 94110 www.integratedcontrolsinc.com ____________________________________________________________ You are subscribed to the PEDA discussion forum To Post messages: mailto:[email protected] Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[email protected] Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[email protected]
