Dennis Saputelli wrote:
how close do y'all pack 0603's side by side ?
Dennis Saputelli
Depends on the asembely method, If Pinck N Place, I ask the board house and go by thier guidance. (I usually ask for a machine ID and specify the design for that machine as in the past they quoted a gap for another machine, and the one they used was knocking parts already placed)
If hand solder, then I usually do a 603, leave a gap of a 603 do a 603 etc.
Regards,
Kat.
-- No virus found in this outgoing message. Checked by AVG Anti-Virus. Version: 7.0.300 / Virus Database: 266.1.0 - Release Date: 18/02/2005
____________________________________________________________ You are subscribed to the PEDA discussion forum
To Post messages: mailto:[email protected]
Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com
Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[email protected]
Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[email protected]
