Dennis Saputelli wrote:
thanks Kat i don't know where these will be built (yet)
i'm sure these numbers are all over the place
what sort of spacings have you seen w/ modern machines ?
i've done stencil/solder paste with hand placement at 50 mil center to center (side by side) and didn't hear any squawking
i have a spot where 40 would be nice :)
Dennis Saputelli
Yeah, 50 mil is about the smallest I go for hand, had one board house in AU who could do 35 mil but it was tight and had alot of issues with solder bridges :( so now I mainly stick to 50mil
Regards,
Kat.
-- No virus found in this outgoing message. Checked by AVG Anti-Virus. Version: 7.0.300 / Virus Database: 266.1.0 - Release Date: 18/02/2005
____________________________________________________________ You are subscribed to the PEDA discussion forum
To Post messages: mailto:[email protected]
Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com
Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[email protected]
Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[email protected]
