but they connect fine if you check pour over same net
ds
_______________________________________________________________________ Integrated Controls, Inc. Tel: 415-647-0480 EXT 107 2851 21st Street Fax: 415-647-3003 San Francisco, CA 94110 www.integratedcontrolsinc.com
Leo Potjewijd wrote:
At 10-3-2005 17:50, Nukien wrote:
<snip> I can't figure out *why* vias connecting to polys wouldn't work. Either it's an oversight by Altium, or it's deliberate.
There is another reason that can cause vias and pads to remain unconnected: certain combinations of clearance and settings (style, conductor width) in the polygone connect rule(s).
Some fiddling with these settings may be required to see if this is the case....
Leo Potjewijd hardware designer Integrated Engineering B.V.
[EMAIL PROTECTED] +31 20 4620700
____________________________________________________________ You are subscribed to the PEDA discussion forum
To Post messages: mailto:[email protected]
Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com
Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[email protected]
Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[email protected]
