Haha! I remember a particular 4 layer PCB done at 4X with T&D. Now that
was challenging. Back in the days where it was important to have a very
clean desk (as I look around on my desk now ;-)
Hey Brad, we are fairly close by, up here in Vernon. "Silicon Vineyard"
as OSTEC would call it ;-).
Stephen Noftall
Level Control Systems
www.LCSaudio.com
Brad Velander wrote:
Wonder no longer Kathy,
By hand, some even use tape and donuts just like we all used to, now
that is going back.
Pushing back the realm of archaeological dating even farther, didn't they
find tape and donuts amongst some dinosaur bones on one dig? 8^>
Sincerely,
Brad Velander
Senior PCB Designer
Northern Airborne Technology
1925 Kirschner Rd.,
Kelowna, BC, V1Y 4N7.
tel (250) 763-2329 ext. 225
fax (250) 762-3374
-----Original Message-----
From: Kathy Quinlan [mailto:[EMAIL PROTECTED]
Sent: June 8, 2005 7:25 PM
To: Protel EDA Discussion List
Subject: Re: [PEDA] Straight jumpers on top layer in auto routing
SNIP
Makes me wonder how consumer electronics people lay their single sided
phonic PCB's out with soo many jumpers ;)
Regards,
Kat.
____________________________________________________________
You are subscribed to the PEDA discussion forum
To Post messages:
mailto:[email protected]
Unsubscribe and Other Options:
http://techservinc.com/mailman/listinfo/peda_techservinc.com
Browse or Search Old Archives (2001-2004):
http://www.mail-archive.com/[email protected]
Browse or Search Current Archives (2004-Current):
http://www.mail-archive.com/[email protected]
____________________________________________________________
You are subscribed to the PEDA discussion forum
To Post messages:
mailto:[email protected]
Unsubscribe and Other Options:
http://techservinc.com/mailman/listinfo/peda_techservinc.com
Browse or Search Old Archives (2001-2004):
http://www.mail-archive.com/[email protected]
Browse or Search Current Archives (2004-Current):
http://www.mail-archive.com/[email protected]
