I've finished the schematic, built up footprints, and previewed the circuit board update and cleaned up several simple errors, such as missing foot- prints or misspelled ones.
But now it's stuck on a node not found error and I can't seem to get it fixed. The error message says it's attempting to add node U222-28 to net RH, and the error is node not found. I've played with it quite a bit. At first I was getting many of the pins as nodes not found. I fooled with reconnecting the pins, refreshing the view, saving everything in save all, and even closing Protel and reopening it. I finally deleted the offending chip and placed another one. Now there's still one pin that it refuses to acknowledge. I also played with swapping nets hooked up to the pin to see if the problem followed the net. It doesn't. It stays right with the -28 pin. I've also tried deleting that pin in the schematic library and then adding it again. Any ideas would be appreciated. Thank you, Michael ____________________________________________________________ You are subscribed to the PEDA discussion forum To Post messages: mailto:[email protected] Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[email protected] Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[email protected]
