Hey Michael, Forgive me if I'm stating the obvious here...
I'm assuming the "node not found" error comes up during the PCB update process. I believe the "node" is referring to the layout footprint pad 28. Basically, protel is trying to add pad 28 to the net RH, but the pad cannot be found. The solution is to make sure that the footprint for U222 in fact has a pad 28. Darcy -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] Behalf Of Robison, Michael R NAVSEA Sent: October 21, 2005 1:59 PM To: Protel EDA Discussion List Subject: [PEDA] Node not found I've finished the schematic, built up footprints, and previewed the circuit board update and cleaned up several simple errors, such as missing foot- prints or misspelled ones. But now it's stuck on a node not found error and I can't seem to get it fixed. The error message says it's attempting to add node U222-28 to net RH, and the error is node not found. I've played with it quite a bit. At first I was getting many of the pins as nodes not found. I fooled with reconnecting the pins, refreshing the view, saving everything in save all, and even closing Protel and reopening it. I finally deleted the offending chip and placed another one. Now there's still one pin that it refuses to acknowledge. I also played with swapping nets hooked up to the pin to see if the problem followed the net. It doesn't. It stays right with the -28 pin. I've also tried deleting that pin in the schematic library and then adding it again. Any ideas would be appreciated. Thank you, Michael ____________________________________________________________ You are subscribed to the PEDA discussion forum To Post messages: mailto:[email protected] Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[email protected] Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[email protected] ____________________________________________________________ You are subscribed to the PEDA discussion forum To Post messages: mailto:[email protected] Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[email protected] Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[email protected]
