It could be that pin number field in your footprint is entered as <space>28
or in a similar way. You only see 28 on the pad, but protel would not find
it as pin 28 does not exist. Make sure you delete the <space> characters in
front and/or after the pin number.
Cheers,
Igor
From: "Robison, Michael R NAVSEA" <[EMAIL PROTECTED]>
Reply-To: Protel EDA Discussion List <[email protected]>
To: "Protel EDA Discussion List" <[email protected]>
Subject: [PEDA] Node not found
Date: Fri, 21 Oct 2005 14:58:41 -0500
I've finished the schematic, built up footprints, and previewed the circuit
board update and cleaned up several simple errors, such as missing foot-
prints or misspelled ones.
But now it's stuck on a node not found error and I can't seem to get it
fixed. The error message says it's attempting to add node U222-28 to net
RH, and the error is node not found. I've played with it quite a bit. At
first I was getting many of the pins as nodes not found. I fooled with
reconnecting the pins, refreshing the view, saving everything in save all,
and even closing Protel and reopening it. I finally deleted the offending
chip and placed another one. Now there's still one pin that it refuses to
acknowledge.
I also played with swapping nets hooked up to the pin to see if the problem
followed the net. It doesn't. It stays right with the -28 pin. I've
also tried deleting that pin in the schematic library and then adding it
again.
Any ideas would be appreciated.
Thank you, Michael
____________________________________________________________
You are subscribed to the PEDA discussion forum
To Post messages:
mailto:[email protected]
Unsubscribe and Other Options:
http://techservinc.com/mailman/listinfo/peda_techservinc.com
Browse or Search Old Archives (2001-2004):
http://www.mail-archive.com/[email protected]
Browse or Search Current Archives (2004-Current):
http://www.mail-archive.com/[email protected]
_________________________________________________________________
MyCareer.com.au: Visit the NEW Salary Survey
http://www.mycareer.com.au/salary-survey/?s_cid=203697
____________________________________________________________
You are subscribed to the PEDA discussion forum
To Post messages:
mailto:[email protected]
Unsubscribe and Other Options:
http://techservinc.com/mailman/listinfo/peda_techservinc.com
Browse or Search Old Archives (2001-2004):
http://www.mail-archive.com/[email protected]
Browse or Search Current Archives (2004-Current):
http://www.mail-archive.com/[email protected]
