Thanks Rich, Now, as far as the motor assembly's relationship to the bedplate, this Model A uses the three sets of upper and lower springs rather than rubber washers which are solely used between the top works and bedplate. Any reason to supplement the springs with rubber washers as well (although I don't think the 3 screws are long enough to accommodate anything other than the upper and lower springs.)?
Thanks for the heads up on Sorbothane. Best, Michael ----- Original Message ----- From: "Rich" <[email protected]> To: "Antique Phonograph List" <[email protected]> Sent: Tuesday, January 02, 2007 12:49 PM Subject: Re: [Phono-L] Re: Noisy Home > The rubber washers were mentioned. These isolate vibration and should be > as soft as possible. > Natural rubber or sorbothane is a good replacement. Replacements can be > made with a set of gasket > punches and McMaster Carr sells sheet Sorbothane. You can have a motor > that sounds like it was > crushing rocks but the sorbothane will damp all of the vibration and noise > amplification. The > commonly available commercial replacements are a bit hard.... > > I have rebuilt numerous Home A, Triumph A, and Standard A machines and > they are a bit louder than > some of the later machines but not noticeably so. > > Rich
