wow, i just put it in the can and close the lid. :) it always seems to keep itself in place because of the curved wall.
From: "Markus Birsfelder" <[email protected]> Reply-To: pinhole-discussion@p at ??????? List-Post: [email protected] Date: Sat, 22 Dec 2001 07:57:12 +0100 To: <pinhole-discussion@p at ???????> Subject: AW: [pinhole-discussion] loading paper into a cancamera Hi Lukasz To hold the paper in place, I glue two pieces of thick cardboard of about 2 cm2 to the inside of the can. I place one near the bottom and one near the top, both in line with the pinhole. The paper I use is cut to the length of the inner circumference of the can less 3-5 mm. This keeps it safely in place. In some cases, instead of cardboard, I used those self adhesive felt squares that you can buy to stick to the ends of the legs of your chairs to prevent scratching the floor. In a more elaborate version, I drill four holes and weld nails that I have cut to approx. 3mm length into the holes. This technique was necessary when I prepared fairly small cans (5 cm diameter). Markus -----Ursprüngliche Nachricht----- Von: pinhole-discussion-admin@p at ??????? [mailto:pinhole-discussion-admin@p at ???????]Im Auftrag von ?ukasz Kacperczyk Gesendet: Samstag, 22. Dezember 2001 05:27 An: pinhole Betreff: [pinhole-discussion] loading paper into a cancamera Hi there, I'm new here, so my question is quite basic, namely: how do you load (I mean position) paper into a can camera? Do you use a tape that has both sides adhesive, or a normal one-sided tape? How do you make the paper stick to the camera's wall? Thanks in advance, Best regards, ?ukasz Tego nie znajdziesz w zadnym sklepie! [ http://oferty.onet.pl ]
