On Wed, Dec 13, 2000 at 05:45:04PM +0300, Sintsov Dmitri wrote:
> > - I created the three setup floppies (since plex86 can't boot
> > from CD).
> > - I set the boot device to a
> > - I create an image for each floppy
> > - I copied the first image to floppya
> > - I started plex86
> > - plex86 booted from the first floppy and asked for the second
> > after a while.
> > - Then I got the usual blue screen with the build number
> > and "1 System Processor [32 MB Memory] Multiprocessor Kernel".
> > - After a while I got this BSOD:
> >
> > *** STOP: 0x0000007B (0xFF109ED0),0x00000000,0x00000000,0x00000000)
> > INACCESSIBLE_BOOT_DEVICE
> >
> > Any hints what I could do ?
> >
> Perhaps you don't specify hdd disk image file or raw hdd device in
> plex config file for IDE drive emulation? In such case it probably can't
> find HD boot device to install loader.
Here is the cut&paste from the config file:
bochs-opt boot: a
bochs-opt diskc: file=../../483M.NT40, cyl=1024, heads=15, spt=63
bochs-opt cdromd: dev=/dev/cdrom, status=inserted
bochs-opt floppya: 1_44=../../floppya, status=inserted
I created the disk image with dd if=/dev/zero.
--
==============================================
Sowatec AG, CH-8330 Pf�ffikon (ZH)
Witzbergstr. 7, http://www.sowatec.com
Tel: +41-(0)1-952 55 55
Fax: +41-(0)1-952 55 66
----------------------------------------------
Aaron "Optimizer" Digulla, [EMAIL PROTECTED]
==============================================
