You could also try and rename cdrom.sys to cdrom.old in the
\winnt\system32\drivers directory and try and boot again. I would think
that would tell you if it was the cdrom causing the problem
----- Original Message -----
From: "Kevin Lawton" <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Wednesday, December 13, 2000 10:05 AM
Subject: Re: [plex86] Installing WinNT with plex86
> Aaron Optimizer Digulla wrote:
>
> > - After a while I got this BSOD:
> >
> > *** STOP: 0x0000007B (0xFF109ED0),0x00000000,0x00000000,0x00000000)
> > INACCESSIBLE_BOOT_DEVICE
> >
> > Any hints what I could do ?
>
>
> Humm, I was getting this until I enabled CDROM emulation and
> added the cdrom directive in the conf file, even though I
> was using a hard disk image file already installed.
>
> I believe NT will only recognize the (legacy IDE) hard disk if you
> have a CDROM enabled.
>
> Perhaps you need to do 'make dist-clean; ./configure; make'.
>
> -Kevin
>
> --
> =-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-
> Kevin Lawton [EMAIL PROTECTED]
> MandrakeSoft, Inc. Plex86 developer
> http://www.linux-mandrake.com/ http://www.plex86.org/
>
>
