On Fri, Sep 9, 2011 at 3:20 PM, AL Pelias <[email protected]> wrote: > Hi Sir, > > run the following at root prompt: > > 1. runlevel > N 2 > > 2. ifconfig > Pls see attached:ifconfig.jpg > > 3. netstat -ln > Pls see attached:netstat_ln.jpg > > 4. netstat -rn > pls see attached:netstat_rn.jpg > > > sorry for the blurred jpg files.
dont worry it needs a 3D glass to see it clearly :-> runlevel is 2 which is normal to ubuntu server... netstat -rn looks good while its default gateway is 192.168.0.4.. ifconfig shows that your eth1 is up with an ip adddress of 192.168.0.2 and netmask of 255.255.255.0.. netstat -ln shows that no processes are listening to any TCP ports.. thats include your ssh tcp port 22... you have two problems here... 1. eventhough your eth1 is "UP" but it is not in "RUNNING" state... as you can see in your ifconfig output.. lo0 is only UP and RUNNING... if an interface is not in running state.. it wont accept any data... check your cable for any breakage and reinsert both sides (network card and switch port) to tighten up... after that make sure your eth1's state look like this: UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 2. your ssh (and other services) didnt come up after boot.. even if your eth1 is not in running state as long as it is in UP state... ssh will bind to eth1 interface as well as to loopback interface (as loopback interface is always on all the time and assuming ssh is bind to any interface).. check your service status and look for ssh if it is mark as run during boot up... root# service --status-all you can manually run it... root# service ssh start for more info running a service.... https://help.ubuntu.com/community/UbuntuBootupHowto fooler. _________________________________________________ Philippine Linux Users' Group (PLUG) Mailing List http://lists.linux.org.ph/mailman/listinfo/plug Searchable Archives: http://archives.free.net.ph
