I bit the bullet and did a factory reset. The router is now working properly. I have routing configured for my net.
1. I enabled usb again, but had the drive plugged in and rest the router. Last time the drive was not plugged in when I reset. However, I plugged it in and did a power on/off, so not sure if it matters. It turns out the drive is formatted with ntfs, so it cannot be mounted. I will have to reformat it and try that one again. 2. I enabled sshd with the same pubic key, rebooted, and no problems. I am able to ssh into the router. I have no idea what happened, but it seems to be working now. Thanks to everyone for their suggestions! Mark On Sat, Dec 21, 2013 at 1:25 PM, Bill Barry <[email protected]> wrote: > On Sat, Dec 21, 2013 at 11:16 AM, Mark Phillips > <[email protected]>wrote: > > > Actually I would say it is not acting as a router...I think it is dead in > > the water. I cannot access the internet, but I can access my local lan. > > > > > > I still think resetting and re-configuring is the quickest solution, but I > am curious as to what exactly failed. You say it is not acting as a router, > but you are able to connect to the local lan. Is that connecting to the > local lan via the router or if the router was unplugged and put in the > closet would you still be connecting to the local lan. Are you pinging > using IP addresses or using names? i.e. is it a DNS problem. When I first > installed tomato on my ASUS NT-12 router it had telnet open for local > access. Do you maybe have telnet access? Maybe there is another router on > your local lan interfering with things? How about disconnecting all other > systems from the router except the laptop and then seeing if you can get > access. > _______________________________________________ > PLUG mailing list > [email protected] > http://lists.pdxlinux.org/mailman/listinfo/plug > _______________________________________________ PLUG mailing list [email protected] http://lists.pdxlinux.org/mailman/listinfo/plug
