all those Pre-Fail and Old_ages look suspicious... On Tue, Jan 13, 2015 at 1:38 PM, Dick Steffens <[email protected]> wrote:
> On 01/13/2015 01:02 PM, Nat Taylor wrote: > > not sure about destructiveness of smartmontools and "smartctl -a" > > Looks like it's non-destructive. I got this, which appears to say the > disk is fine, unless I misinterpreted something: > > rsteff@ThinkCentre-M58p:~$ sudo smartctl -a /dev/sda > smartctl 5.41 2011-06-09 r3365 [x86_64-linux-3.5.0-18-generic] (local > build) > Copyright (C) 2002-11 by Bruce Allen, http://smartmontools.sourceforge.net > > === START OF INFORMATION SECTION === > Model Family: Seagate Barracuda 7200.12 > Device Model: ST3320418AS > Serial Number: 6VM97DR5 > LU WWN Device Id: 5 000c50 01ed8e39b > Firmware Version: CC66 > User Capacity: 320,072,933,376 bytes [320 GB] > Sector Size: 512 bytes logical/physical > Device is: In smartctl database [for details use: -P show] > ATA Version is: 8 > ATA Standard is: ATA-8-ACS revision 4 > Local Time is: Tue Jan 13 13:15:37 2015 PST > SMART support is: Available - device has SMART capability. > SMART support is: Enabled > > === START OF READ SMART DATA SECTION === > SMART overall-health self-assessment test result: PASSED > > General SMART Values: > Offline data collection status: (0x82) Offline data collection activity > was completed without error. > Auto Offline Data Collection: Enabled. > Self-test execution status: ( 0) The previous self-test > routine completed > without error or no self-test has ever > been run. > Total time to complete Offline > data collection: ( 625) seconds. > Offline data collection > capabilities: (0x7b) SMART execute Offline immediate. > Auto Offline data collection on/off support. > Suspend Offline collection upon new > command. > Offline surface scan supported. > Self-test supported. > Conveyance Self-test supported. > Selective Self-test supported. > SMART capabilities: (0x0003) Saves SMART data before entering > power-saving mode. > Supports SMART auto save timer. > Error logging capability: (0x01) Error logging supported. > General Purpose Logging supported. > Short self-test routine > recommended polling time: ( 1) minutes. > Extended self-test routine > recommended polling time: ( 68) minutes. > Conveyance self-test routine > recommended polling time: ( 2) minutes. > SCT capabilities: (0x103f) SCT Status supported. > SCT Error Recovery Control supported. > SCT Feature Control supported. > SCT Data Table supported. > > SMART Attributes Data Structure revision number: 10 > Vendor Specific SMART Attributes with Thresholds: > ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED > WHEN_FAILED RAW_VALUE > 1 Raw_Read_Error_Rate 0x000f 117 099 006 Pre-fail > Always - 148741208 > 3 Spin_Up_Time 0x0003 097 097 000 Pre-fail > Always - 0 > 4 Start_Stop_Count 0x0032 100 100 020 Old_age > Always - 934 > 5 Reallocated_Sector_Ct 0x0033 100 100 036 Pre-fail > Always - 0 > 7 Seek_Error_Rate 0x000f 084 060 030 Pre-fail > Always - 259660219 > 9 Power_On_Hours 0x0032 058 058 000 Old_age > Always - 37456 > 10 Spin_Retry_Count 0x0013 100 100 097 Pre-fail > Always - 0 > 12 Power_Cycle_Count 0x0032 100 100 020 Old_age > Always - 466 > 183 Runtime_Bad_Block 0x0032 100 100 000 Old_age > Always - 0 > 184 End-to-End_Error 0x0032 100 100 099 Old_age > Always - 0 > 187 Reported_Uncorrect 0x0032 100 100 000 Old_age > Always - 0 > 188 Command_Timeout 0x0032 100 098 000 Old_age > Always - 66256 > 189 High_Fly_Writes 0x003a 100 100 000 Old_age > Always - 0 > 190 Airflow_Temperature_Cel 0x0022 065 052 045 Old_age > Always - 35 (Min/Max 31/44) > 194 Temperature_Celsius 0x0022 035 048 000 Old_age > Always - 35 (0 9 0 0) > 195 Hardware_ECC_Recovered 0x001a 048 033 000 Old_age > Always - 148741208 > 197 Current_Pending_Sector 0x0012 100 100 000 Old_age > Always - 0 > 198 Offline_Uncorrectable 0x0010 100 100 000 Old_age > Offline - 0 > 199 UDMA_CRC_Error_Count 0x003e 200 200 000 Old_age > Always - 0 > 240 Head_Flying_Hours 0x0000 100 253 000 Old_age > Offline - 272674588759705 > 241 Total_LBAs_Written 0x0000 100 253 000 Old_age > Offline - 1149999113 > 242 Total_LBAs_Read 0x0000 100 253 000 Old_age > Offline - 1092811368 > > SMART Error Log Version: 1 > No Errors Logged > > SMART Self-test log structure revision number 1 > Num Test_Description Status Remaining > LifeTime(hours) LBA_of_first_error > # 1 Vendor (0x50) Completed without error 00% 0 - > > SMART Selective self-test log data structure revision number 1 > SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS > 1 0 0 Not_testing > 2 0 0 Not_testing > 3 0 0 Not_testing > 4 0 0 Not_testing > 5 0 0 Not_testing > Selective self-test flags (0x0): > After scanning selected spans, do NOT read-scan remainder of disk. > If Selective self-test is pending on power-up, resume after 0 minute delay. > > > -- > Regards, > > Dick Steffens > > _______________________________________________ > PLUG mailing list > [email protected] > http://lists.pdxlinux.org/mailman/listinfo/plug > _______________________________________________ PLUG mailing list [email protected] http://lists.pdxlinux.org/mailman/listinfo/plug
