9 Power_On_Hours 0x0032 058 058 000 Old_age Always - 37456 10 Spin_Retry_Count 0x0013 100 100 097 Pre-fail Always - 0 12 Power_Cycle_Count 0x0032 100 100 020 Old_age Always - 466
-thats 37456 Power_On_Hours and 466 Power_Cycle_Count My guess is that you're right on about your disk getting old, and should replace asap On Tue, Jan 13, 2015 at 1:51 PM, Nat Taylor <[email protected]> wrote: > all those Pre-Fail and Old_ages look suspicious... > > On Tue, Jan 13, 2015 at 1:38 PM, Dick Steffens <[email protected]> > wrote: > >> On 01/13/2015 01:02 PM, Nat Taylor wrote: >> > not sure about destructiveness of smartmontools and "smartctl -a" >> >> Looks like it's non-destructive. I got this, which appears to say the >> disk is fine, unless I misinterpreted something: >> >> rsteff@ThinkCentre-M58p:~$ sudo smartctl -a /dev/sda >> smartctl 5.41 2011-06-09 r3365 [x86_64-linux-3.5.0-18-generic] (local >> build) >> Copyright (C) 2002-11 by Bruce Allen, >> http://smartmontools.sourceforge.net >> >> === START OF INFORMATION SECTION === >> Model Family: Seagate Barracuda 7200.12 >> Device Model: ST3320418AS >> Serial Number: 6VM97DR5 >> LU WWN Device Id: 5 000c50 01ed8e39b >> Firmware Version: CC66 >> User Capacity: 320,072,933,376 bytes [320 GB] >> Sector Size: 512 bytes logical/physical >> Device is: In smartctl database [for details use: -P show] >> ATA Version is: 8 >> ATA Standard is: ATA-8-ACS revision 4 >> Local Time is: Tue Jan 13 13:15:37 2015 PST >> SMART support is: Available - device has SMART capability. >> SMART support is: Enabled >> >> === START OF READ SMART DATA SECTION === >> SMART overall-health self-assessment test result: PASSED >> >> General SMART Values: >> Offline data collection status: (0x82) Offline data collection >> activity >> was completed without error. >> Auto Offline Data Collection: Enabled. >> Self-test execution status: ( 0) The previous self-test >> routine completed >> without error or no self-test has ever >> been run. >> Total time to complete Offline >> data collection: ( 625) seconds. >> Offline data collection >> capabilities: (0x7b) SMART execute Offline immediate. >> Auto Offline data collection on/off support. >> Suspend Offline collection upon new >> command. >> Offline surface scan supported. >> Self-test supported. >> Conveyance Self-test supported. >> Selective Self-test supported. >> SMART capabilities: (0x0003) Saves SMART data before >> entering >> power-saving mode. >> Supports SMART auto save timer. >> Error logging capability: (0x01) Error logging supported. >> General Purpose Logging supported. >> Short self-test routine >> recommended polling time: ( 1) minutes. >> Extended self-test routine >> recommended polling time: ( 68) minutes. >> Conveyance self-test routine >> recommended polling time: ( 2) minutes. >> SCT capabilities: (0x103f) SCT Status supported. >> SCT Error Recovery Control supported. >> SCT Feature Control supported. >> SCT Data Table supported. >> >> SMART Attributes Data Structure revision number: 10 >> Vendor Specific SMART Attributes with Thresholds: >> ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED >> WHEN_FAILED RAW_VALUE >> 1 Raw_Read_Error_Rate 0x000f 117 099 006 Pre-fail >> Always - 148741208 >> 3 Spin_Up_Time 0x0003 097 097 000 Pre-fail >> Always - 0 >> 4 Start_Stop_Count 0x0032 100 100 020 Old_age >> Always - 934 >> 5 Reallocated_Sector_Ct 0x0033 100 100 036 Pre-fail >> Always - 0 >> 7 Seek_Error_Rate 0x000f 084 060 030 Pre-fail >> Always - 259660219 >> 9 Power_On_Hours 0x0032 058 058 000 Old_age >> Always - 37456 >> 10 Spin_Retry_Count 0x0013 100 100 097 Pre-fail >> Always - 0 >> 12 Power_Cycle_Count 0x0032 100 100 020 Old_age >> Always - 466 >> 183 Runtime_Bad_Block 0x0032 100 100 000 Old_age >> Always - 0 >> 184 End-to-End_Error 0x0032 100 100 099 Old_age >> Always - 0 >> 187 Reported_Uncorrect 0x0032 100 100 000 Old_age >> Always - 0 >> 188 Command_Timeout 0x0032 100 098 000 Old_age >> Always - 66256 >> 189 High_Fly_Writes 0x003a 100 100 000 Old_age >> Always - 0 >> 190 Airflow_Temperature_Cel 0x0022 065 052 045 Old_age >> Always - 35 (Min/Max 31/44) >> 194 Temperature_Celsius 0x0022 035 048 000 Old_age >> Always - 35 (0 9 0 0) >> 195 Hardware_ECC_Recovered 0x001a 048 033 000 Old_age >> Always - 148741208 >> 197 Current_Pending_Sector 0x0012 100 100 000 Old_age >> Always - 0 >> 198 Offline_Uncorrectable 0x0010 100 100 000 Old_age >> Offline - 0 >> 199 UDMA_CRC_Error_Count 0x003e 200 200 000 Old_age >> Always - 0 >> 240 Head_Flying_Hours 0x0000 100 253 000 Old_age >> Offline - 272674588759705 >> 241 Total_LBAs_Written 0x0000 100 253 000 Old_age >> Offline - 1149999113 >> 242 Total_LBAs_Read 0x0000 100 253 000 Old_age >> Offline - 1092811368 >> >> SMART Error Log Version: 1 >> No Errors Logged >> >> SMART Self-test log structure revision number 1 >> Num Test_Description Status Remaining >> LifeTime(hours) LBA_of_first_error >> # 1 Vendor (0x50) Completed without error 00% 0 - >> >> SMART Selective self-test log data structure revision number 1 >> SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS >> 1 0 0 Not_testing >> 2 0 0 Not_testing >> 3 0 0 Not_testing >> 4 0 0 Not_testing >> 5 0 0 Not_testing >> Selective self-test flags (0x0): >> After scanning selected spans, do NOT read-scan remainder of disk. >> If Selective self-test is pending on power-up, resume after 0 minute >> delay. >> >> >> -- >> Regards, >> >> Dick Steffens >> >> _______________________________________________ >> PLUG mailing list >> [email protected] >> http://lists.pdxlinux.org/mailman/listinfo/plug >> > > _______________________________________________ PLUG mailing list [email protected] http://lists.pdxlinux.org/mailman/listinfo/plug
