On Sat, 7 Dec 2019, wes wrote:
Specifically, and I'm only pointing this out in the hopes this will be
helpful in the future:
# ip add show eth0
2: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq state UP group
default qlen 1000
link/ether b8:ac:6f:69:63:ca brd ff:ff:ff:ff:ff:ff
inet6 fe80::baac:6fff:fe69:63ca/64 scope link
valid_lft forever preferred_lft forever
where is the "inet" line? You should have one similar to this:
Wes,
Update: restored config.boot on new ER-X. Now it has IP address
192.168.55.4.
Reset Dell 2100's eth0 to 192.168.55.3. Restarted rc.inet1; rebooted Dell.
That should put both hosts on 192.168.55.0/24. Yet once again I cannot reach
the router via ping or the web interface. Yet,
# ip add show eth0
2: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq state UP group default qlen 1000
link/ether b8:ac:6f:69:63:ca brd ff:ff:ff:ff:ff:ff
inet 192.168.55.3/24 brd 192.168.55.255 scope global eth0
valid_lft forever preferred_lft forever
inet6 fe80::baac:6fff:fe69:63ca/64 scope link
valid_lft forever preferred_lft forever
inet4 line is present. Dell network reconfigured and restarted, system
rebooted, 'ip r' shows a working route:
192.168.55.0/24 dev eth0 proto kernel scope link src 192.168.55.3
but network is still unreachable. Shouldn't be.
Stymied again,
Rich
_______________________________________________
PLUG mailing list
PLUG@pdxlinux.org
http://lists.pdxlinux.org/mailman/listinfo/plug
