Thanks for the prompt reply. I certainly *had* enabled Susend & Hibernate in the SC Settings | Plugins | Server Power Control GUI, although that was immediately after installation. At that point, I hadn't got pm-suspend, etc. on the SC server. I'll go back & check the settings are still enabled.
As an aside, and thanks for the advice, the WOL situation doesn't look too good for me. I'd setup an ethtool script, and installed it with update-rc.d. The WOL 'g' state still didn't seem to persist through reboots. So, also put the script in /etc/pm-suspend/sleep.d/ - that seemed to help. Still couldn't get the box to WOL (have been using various WOL Magic Packet generators to test, and have only just got the correct server MAC address into my SB...). But, have just come across this, which I think (I'm at work) refers to my Mini-ITX mobo: http://gentoo-wiki.com/VIA_Epia_M_II - the relevant section states: "Wake-On-Lan (WOL) will allow you to power up your computer remotely from a powered-off state. However, it won't work when you are in a S3 state (suspend to RAM). This is probably due to either a bug in the via-rhine driver, or in TuxOnIce. I'm not sure whether it will work in a S1 state or not since I don't use S1 very often." I'll set the BIOS to S1, and see what happens... Cheers, Jon -- jonhd ------------------------------------------------------------------------ jonhd's Profile: http://forums.slimdevices.com/member.php?userid=864 View this thread: http://forums.slimdevices.com/showthread.php?t=48521 _______________________________________________ plugins mailing list [email protected] http://lists.slimdevices.com/lists/listinfo/plugins
