> I thought the real problem wasn't so much being > Cardbus enabled. Like you, I thought you could load > the proper drivers and get away with that... But I > thought the problem was more that the PCMCIA Card Cage > that is installed in the 3400 from the factory won't > accept some of the CardBus cards... I think thats > what your paying the $99 for.... to get them to swap > out your cage... >
I dont know much about PCMCIA Card Cages but if the problem is getting the card fit into the slot, (is it the same thing?), all I did was use the finest grit sandpaper I could find and sand off a little bit off the edge of the Macally card and then, it fit into the slot quite nicely Hope that helps... and YMMV -- PowerBooks is sponsored by <http://lowendmac.com/> and... Small Dog Electronics http://www.smalldog.com | Enter To Win A | -- Canon PowerShot Digital Cameras start at $299 | Free iBook! | RoadTools $30 PodiumPad available at Apple retail stores, $20 Traveler CoolPad at Staples. Both in white for iBooks at <http://roadtools.com>. Support Low End Mac <http://lowendmac.com/lists/support.html> PowerBooks list info: <http://lowendmac.com/lists/powerbooks.shtml> Send list messages to: <mailto:[EMAIL PROTECTED]> To unsubscribe, email: <mailto:[EMAIL PROTECTED]> For digest mode, email: <mailto:[EMAIL PROTECTED]> Subscription questions: <mailto:[EMAIL PROTECTED]> Archive: <http://www.mail-archive.com/powerbooks%40mail.maclaunch.com/> Using a Mac? Free email & more at Applelinks! http://www.applelinks.com
