As an alternative to SET STEP ON, I would suggest ASSERT .f. That way, if you forget to remove it later, it has no impact in an EXE.
Rick Schummer wrote: > You can still run the SPR code gen'd in 2.6 in VFP and you can trace the > code. Rebuild the project > and make sure to check on the Debug Info in the Project Manager's Project > Info dialog (off the > Project menu, or right-click on the Project Manager). You can trace code in > the VFP forms too. Just > SET STEP ON in the form Load() method. > > -- Richard Kaye Vice President Artfact/RFC Systems Voice: 617.219.1038 Fax: 617.219.1001 For the fastest response time, please send your support queries to: Technical Support - [EMAIL PROTECTED] Australian Support - [EMAIL PROTECTED] Internet Support - [EMAIL PROTECTED] All Other Requests - [EMAIL PROTECTED] --------------------------------------------------------- This message has been checked for viruses before sending. --------------------------------------------------------- _______________________________________________ Post Messages to: [email protected] Subscription Maintenance: http://leafe.com/mailman/listinfo/profox OT-free version of this list: http://leafe.com/mailman/listinfo/profoxtech Searchable Archive: http://leafe.com/archives/search/profox This message: http://leafe.com/archives/byMID/profox/[EMAIL PROTECTED] ** All postings, unless explicitly stated otherwise, are the opinions of the author, and do not constitute legal or medical advice. This statement is added to the messages for those lawyers who are too stupid to see the obvious.
