I am not very sure, but their execution stack are different. I cannot remember if I had used menu run to load scripts in the J6 days. Usually I loaded a project and ran as what you had said.
Вс, 02 окт 2016, Chris Burke написал(а): > Perhaps simpler: > > myrun_z_=: 3 : 0 > load wd'mb open1 run . "*.ijs"' > ) > > But there are better options. The IDE is primarily a development > environment, so nearly always you want to open source for editing and > testing. There are various ways to do this, but the main and recommended > method is to use the editor with projects, see > code.jsoftware.com/wiki/Guides/Folders_and_Projects. A few minutes spent > learning this will save a lot of time. > > If you just want to run a script somewhere on the system, then rather than > spending time navigating up and down directories to look for it, try one of: > > * add the script to the Launch Pad > > * create a desktop shortcut that loads J with the script as parameter > > * create a script with your favorite "load xxx" commands. Open this and run > the required line. > > * use projects and the project run buttons. > > On 2 October 2016 at 03:40, bill lam <bbill....@gmail.com> wrote: > > > You can define a verb in startup.ijs to choose and run scripts > > > > myrun_z_=: 3 : 0 > > empty (libjqt, ' immexj + n *c')&cd <'0!:100<', quote wd'mb open1 run . > > "*.ijs"' > > ) > > > > Also the verb can be binded to a function key in the ide, > > see menu Edit>configure>user keys > > > ---------------------------------------------------------------------- > For information about J forums see http://www.jsoftware.com/forums.htm -- regards, ==================================================== GPG key 1024D/4434BAB3 2008-08-24 gpg --keyserver subkeys.pgp.net --recv-keys 4434BAB3 gpg --keyserver subkeys.pgp.net --armor --export 4434BAB3 ---------------------------------------------------------------------- For information about J forums see http://www.jsoftware.com/forums.htm
