Hate to state the obvious, but did you set up all relevant clearance parameters? ----- Original Message ----- From: Ted Tontis <[EMAIL PROTECTED]> To: Multiple recipients of list proteledausers <[EMAIL PROTECTED]> Sent: Tuesday, 6 February 2001 08:51 Subject: [PROTEL EDA USERS]: Polygon plane problem > > I think someone already covered this problem, I could not find the response > to it. I am running 99SE with service pack 6 on windows 2k, I did my whole > project on this setup. I am now trying to pore a polygon plane and I am not > getting anywhere with it. When pored on the top layer of my board it fails > to leave a gap between the vias and traces leading to other parts. when I > double click on the pad or via on the plane I get a DRC error (short > circuit) when I double click on the polygon (one trace of it) it has no net > value. I have tried to pore it a number of times and still the same results. > I imported the Ddb to a computer running 99SE service pack 5 and still I get > the same results. I sent Protel a e-mail regarding this but I do not expect > them to get right on it. I hope anyone might have a idea or something to > help me get this problem fixed, they want to get this board into the proto > shop some time this week. > > Thank you, > Ted Tontis > Design Engineer > Engage Networks Inc. > [EMAIL PROTECTED] > PH 414.273.7600 Ext. 7607 <http://www.engagenet.com> > > > > > * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * > * This message sent by: PROTEL EDA USERS MAILING LIST > * > * Use the "reply" command in your email program to > * respond to this message. > * > * To unsubscribe from this mailing list use the form at > * the Association web site. You will need to give the same > * email address you originally used to subscribe (do not > * give an alias unless it was used to subscribe). > * > * Visit http://www.techservinc.com/protelusers/subscrib.html > * to unsubscribe or to subscribe a new email address. > * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * > * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * This message sent by: PROTEL EDA USERS MAILING LIST * * Use the "reply" command in your email program to * respond to this message. * * To unsubscribe from this mailing list use the form at * the Association web site. You will need to give the same * email address you originally used to subscribe (do not * give an alias unless it was used to subscribe). * * Visit http://www.techservinc.com/protelusers/subscrib.html * to unsubscribe or to subscribe a new email address. * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * ________________________________________________________ To leave the EDAFORUM discussion list, send a email with 'leave edaforum' in the body to '[EMAIL PROTECTED]' More Information : http://www.dolist.net