Hello all,
I have a one-page schematic that I created mostly by block copying parts of other 99SE
schematics. Some of the reference designators are duplicates, others are new with
question marks and so-forth. I have tried to reset designators and then annotate, and
I also tried to annotate all. All that happens is that I get a blank report file and
none of the designators have changed.
If I export the schematic and the library that I created into 98 schematic, the above
annotate functions work fine, I then import the schematic back to 99SE and all is well.
Is there something that I am doing wrong in 99SE?
The above is both with SP5 and SP6.
Andrew W. Riley III
Talon Instruments
150 East Arrow Highway
San Dimas, California 91773
(909) 599-0690 [voice]
(909) 599-6529 [fax]
www.taloninst.com
[EMAIL PROTECTED]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* This message sent by: PROTEL EDA USERS MAILING LIST
*
* Use the "reply" command in your email program to
* respond to this message.
*
* To unsubscribe from this mailing list use the form at
* the Association web site. You will need to give the same
* email address you originally used to subscribe (do not
* give an alias unless it was used to subscribe).
*
* Visit http://www.techservinc.com/protelusers/subscrib.html
* to unsubscribe or to subscribe a new email address.
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
________________________________________________________
To leave the EDAFORUM discussion list, send a email with
'leave edaforum' in the body to '[EMAIL PROTECTED]'
More Information : http://www.dolist.net