Forgive/rtfm (rtfa?) me if this has been covered recently. How do we check that each sheet symbol and its associated sheet have the correct port names, other than a manual netlist check to ensure things are connected correctly? It's pretty vital in a big hierarchical sheet-symbol/port-connections scope for identifying bad port names (or a missing overbar! but of course good engineers don't use them). I just now tried removing the port entry on a sheet and running the ERC to see if anything at all comes up - no errors, and the only evidence is the broken net in the netlist. All ears, Drew -- Drew Lundsten <[EMAIL PROTECTED]> direct +1.858.882.8828 Continuous Computing Corporation fax +1.858.777.3388 9380 Carroll Park Dr, San Diego 92121 cell +1.619.847.4251 * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * This message sent by: PROTEL EDA USERS MAILING LIST * * Use the "reply" command in your email program to * respond to this message. * * To unsubscribe from this mailing list use the form at * the Association web site. You will need to give the same * email address you originally used to subscribe (do not * give an alias unless it was used to subscribe). * * Visit http://www.techservinc.com/protelusers/subscrib.html * to unsubscribe or to subscribe a new email address. * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * ________________________________________________________ To leave the EDAFORUM discussion list, send a email with 'leave edaforum' in the body to '[EMAIL PROTECTED]' More Information : http://www.dolist.net
