I calculate ( pad-size - hole size )/2 = annular ring perhaps kangaroos do it with new math. :-) Georg [EMAIL PROTECTED] > -----Urspr ngliche Nachricht----- > Von: TSListServer [mailto:[EMAIL PROTECTED]]Im > Auftrag von Micky Blain > Gesendet: Mittwoch, 14. Februar 2001 17:56 > An: Multiple recipients of list proteledausers > Betreff: [PROTEL EDA USERS]: Annular Ring > > > There is some debit going on at this company about the way > Protel calculate > Annular Ring. They are using dia-hole and dia of pad to calculate the > number. I am being told that is not right. > > I have the Annular ring design rules set to 8mil in Protel > and the debit is > that is a 4 mil annular ring. > > > Any discussion on this one? > > Micky Blain > > > > * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * > * This message sent by: PROTEL EDA USERS MAILING LIST > * > * Use the "reply" command in your email program to > * respond to this message. > * > * To unsubscribe from this mailing list use the form at > * the Association web site. You will need to give the same > * email address you originally used to subscribe (do not > * give an alias unless it was used to subscribe). > * > * Visit http://www.techservinc.com/protelusers/subscrib.html > * to unsubscribe or to subscribe a new email address. > * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * > * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * This message sent by: PROTEL EDA USERS MAILING LIST * * Use the "reply" command in your email program to * respond to this message. * * To unsubscribe from this mailing list use the form at * the Association web site. You will need to give the same * email address you originally used to subscribe (do not * give an alias unless it was used to subscribe). * * Visit http://www.techservinc.com/protelusers/subscrib.html * to unsubscribe or to subscribe a new email address. * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * ________________________________________________________ To leave the EDAFORUM discussion list, send a email with 'leave edaforum' in the body to '[EMAIL PROTECTED]' More Information : http://www.dolist.net
