Dave,

If you go to your control panel in Windows, then to the ODBC area.  Look
under the Drivers tab and check the version for the Microsoft Access Driver.
You may just need to download and install updated ODBC drivers.  These
drivers are contained in the MDAC.

http://www.microsoft.com/data/download.htm


----------------------------------------------------------------------
Colby Siemer                        ** Custom Battery Chargers
                                           ** Custom Power Supplies
PowerStream Technology       ** Custom UPS
140 S. Mountainway Drive      ** Custom DC/DC Converters
Orem Utah 84058                  ** Power management electronics for OEMs

http://www.PowerStream.com

----- Original Message -----
From: <[EMAIL PROTECTED]>
To: Multiple recipients of list proteledausers
<[EMAIL PROTECTED]>
Sent: Tuesday, February 27, 2001 7:15 AM
Subject: [PROTEL EDA USERS]: Microsoft error


>
>
> Has anyone seen the following error - [microsoft][odbc microsoft access 97
> driver] too few parameters. expected 30 - whilst generating Gerber files
from
> CAM Manager. This only occurs with on specific database, however,  using
the
> repair database utility does not fix the problem. Other db's can be loaded
and
> Gerber's generated OK. This would seem to indicate the problem is specific
to
> that one db. Has anyone come accross this problem before?
>
> CONFIDENTIALITY : This  e-mail  and  any attachments are confidential and
may be
> privileged. If  you are not a named recipient, please notify the sender
> immediately and do not disclose the contents to another person, use it for
any
> purpose or store or copy the information in any medium.
>
>
>
> * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
> *  This message sent by: PROTEL EDA USERS MAILING LIST
> *
> *  Use the "reply" command in your email program to
> *  respond to this message.
> *
> *  To unsubscribe from this mailing list use the form at
> *  the Association web site. You will need to give the same
> *  email address you originally used to subscribe (do not
> *  give an alias unless it was used to subscribe).
> *
> *  Visit http://www.techservinc.com/protelusers/subscrib.html
> *  to unsubscribe or to subscribe a new email address.
> * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
>


* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
*  This message sent by: PROTEL EDA USERS MAILING LIST
*
*  Use the "reply" command in your email program to
*  respond to this message.
*
*  To unsubscribe from this mailing list use the form at
*  the Association web site. You will need to give the same
*  email address you originally used to subscribe (do not
*  give an alias unless it was used to subscribe).
*
*  Visit http://www.techservinc.com/protelusers/subscrib.html
*  to unsubscribe or to subscribe a new email address.
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

________________________________________________________
To leave the EDAFORUM discussion list, send a email with
'leave edaforum' in the body to '[EMAIL PROTECTED]'

Reply via email to