Hello All,
        Has any one tried using CAMtastic 2000 to perform  design rule checking of
the gerbers generated with Protel 99SE.  I just gave it a shot and it tells
me that I have pad to pad clearance problems.  When I go in manually and
measure the problem areas using the  point to point  measurement option in
CAMtastic,  it states that everything is within the defaults that I have
set.

        Protel s Knowledge Base item number #2062 states that you can go to
www.innovativecad.com for support but the web page seems to be down or
missing.

        Any information will be gladly appreciated.  Thank you for your time and
have a nice day.



John Branthoover            :
Electrical Design Engineer  :
Acutronic  R & D            :Phone  (412) 968-1051
137/139 Delta Drive         :Fax    (412) 963-0519
Pittsburgh PA 15238         :Email  [EMAIL PROTECTED]
USA                         :WEB    http://www.acutronic.com

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To join or leave this list visit:
* http://www.techservinc.com/protelusers/subscrib.html
*                      - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to