Speaking of the Camtastic software, does anyone know where I can find some
information on how to use this software. I tried to learn how to use it last
week, but I could not figure out how to add break tabs to my panel. Is there
a tutorial or manual for this software ?
Documentation would be a great asset. I found the help menus quite limited.
Daniel Webster
Northern Airborne Technology
Kelowna, BC, Canada
> ----------
> From: John Branthoover[SMTP:[EMAIL PROTECTED]]
> Reply To: Protel EDA Forum
> Sent: Monday, March 26, 2001 1:44 PM
> To: [EMAIL PROTECTED]
> Subject: [PEDA] CAMtastic 2000 and DRC Checking Of Gerbers....?
>
> Hello All,
> Has any one tried using CAMtastic 2000 to perform design rule
> checking of
> the gerbers generated with Protel 99SE. I just gave it a shot and it
> tells
> me that I have pad to pad clearance problems. When I go in manually and
> measure the problem areas using the point to point measurement option in
> CAMtastic, it states that everything is within the defaults that I have
> set.
>
> Protel s Knowledge Base item number #2062 states that you can go to
> www.innovativecad.com for support but the web page seems to be down or
> missing.
>
> Any information will be gladly appreciated. Thank you for your time
> and
> have a nice day.
>
>
>
> John Branthoover :
> Electrical Design Engineer :
> Acutronic R & D :Phone (412) 968-1051
> 137/139 Delta Drive :Fax (412) 963-0519
> Pittsburgh PA 15238 :Email [EMAIL PROTECTED]
> USA :WEB http://www.acutronic.com
>
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To join or leave this list visit:
* http://www.techservinc.com/protelusers/subscrib.html
* - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *