Thanks but this is what I got from the knowledge base:

The Protel Knowledge Base is temporarily out or service as it is currently
being upgraded.
 
We apologize for any inconvenience.

Thanks for all the replies, I think I've removed all the little !@#%ers.

> -----Original Message-----
> From: Amy Nolen [mailto:[EMAIL PROTECTED]]
> Sent: Tuesday, 7 August 2001 10:39 PM
> To: 'Protel EDA Forum'
> Subject: Re: [PEDA] lost polygons
> 
> 
> Hi Thomas,
> 
> You can go on the Protel knowledge base and Item#1516 will 
> tell you how to
> remove phantom polygons.
> 
> Thanks,
> Amy Nolen
> PCB Layout Technician
> RF Micro Devices
> 7914 Piedmont Triad Parkway
> Greensboro NC 27409
> (336) 931-7099
> 
> 
> -----Original Message-----
> From: Thomas [mailto:[EMAIL PROTECTED]]
> Sent: Tuesday, August 07, 2001 1:01 AM
> To: '[EMAIL PROTECTED]'
> Subject: [PEDA] lost polygons
> 
> 
> Is there any way to make lost polygon fills visible? Or delete them?
> 
> By lost I mean that 'connect to net' and 'remove dead copper' 
> were selected
> for a polygon fill and through updating, or copying from one design to
> another, the net name has been removed, and so the polygon 
> disappears. 
> 
> Although it is still 'there' as I am still asked to repour it 
> if I 'select
> all' objects in the pcb workspace and move the selection slightly.
> 
> I hope this is not clear as mud.
> 
> Tom.
> 
> ---------------------------------------
> Powercom Consultants Pty Ltd 
> Electronics & Communications Engineers
> PH +61 3 62297966  Fax +61 3 62299245
> ---------------------------------------
> 

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*                      - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to