No Problem, i can send it to you, we use this device so the footprint is
very well tested :-)
If you want contact me.
Dipl.-Ing. (FH) Michael Schmitt
Baumer Ident GmbH
Entwicklung / Development Department
Hertzstr. 10
D-69469 Weinheim
Deutschland / Germany
Tel. +49 (0) 6201 9957 - 30
Fax. +49 (0) 6201 9957 - 99
E-Mail : [EMAIL PROTECTED]
Web: http://www.baumerident.com
[EMAIL PROTECTED] schrieb:
>
> Hi,
>
> I need a landing pattern for Altera p/n EP1K30TC144-2. The package is a 144
> Pin TQFP package.
>
> I typically use the recommended landing pattern from the manufacturer;
> however, Altera only provides the physical dimensions of the part itself. I
> attempted to use the land pattern calculator, on the IPC website, using these
> dimensions, but the pad size was clearly calculated incorrectly (one
> dimension of the pad was the width of the entire part).
>
> At this point, I think I'll return to the IPC website to isolate my problem.
> I'd appreciate learning how others handle this situation.
>
> Thanks,
> Steve Allen
--
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[email protected]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *