Just do a select all, copy and then paste into a Word Document.

Dave Adams
Electronics Design Engineer
Safco Corporation

-----Original Message-----
From: Ray Mitchell [mailto:[EMAIL PROTECTED]]
Sent: Wednesday, November 14, 2001 2:39 PM
To: Protel EDA Forum
Subject: [PEDA] Exporting a schematic as a simple jpg, bmp, gif, etc.


Hello,

I would like to use Protel 99SE to draw some schematics with the intent of 
eventually using these schematics simply as drawings, as if I had drawn 
them with Visio, Corel, Micrographics, Paintshop, or some other generic 
drawing program.  I would then like to insert these drawings into Word, 
Wordpad, or whatever.  Does anyone have any insight into doing this?

Thanks,
Ray Mitchell
SPAWAR Systems Center
San Diego, Ca. 92152
(619)553-5344

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to