I would like to paste an array of free (through-hole) pads on .1" centers, all attached to GND net. The array of pads covers the entire board area. So far, no problem. What I would like to know is this: Is there a way to automatically remove or select just the pads which end up causing DRC violations? This type of GND via "peppering" is an engineering requirement, and this is a large, dense board. I am just trying to find some alternative to jumping to each DRC violation and removing the offending pad.
Cheers, -- Mark Richards ON Semiconductor 5005 E. McDowell Road Phoenix, Arizona 85008 Phone: 602.244.7267 Pager: 866-208-9913 * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/proteledaforum@techservinc.com * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *