I am setting up a chip & wire test PCB master, and I would like to use
"square" vias. The only way to make the existing vias square, is to select
them all and convert them to free pads. Or can I substitute free pads for
vias while routing?

Sean James
PCB Designer
Telecast Fiber Systems, Inc.
102 Grove Street
Worcester, MA 01605
(TEL) 508.754.4858 x33
(FAX) 413.541.6170


* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to